Considerations for Installing Solar Street Lights

ZGSM Solar

Installing Solar Street Lights: Do a good job in checking three aspects, and don’t leave hidden dangers due to details

Installing Solar Street Lights

Compared with traditional city circuit lights, the installation of solar street lights is simple. Just dig a hole to make a cement base and stand it up. But the simpler, the less mistakes can be made. After the solar street lights are installed, you need to Pay attention to check the overall installation effect of the street lights to avoid leaving some hidden dangers and affecting the lighting experience.

Stability of Street light pole

First of all, the street light pole must ensure that there is no tilt and that every direction is perpendicular to the ground. If there is a tilt, it must be adjusted in time to ensure balanced force. Secondly, the light pole must be stable and solid. First, it must ensure that it can provide continuous and balanced lighting. Second, Ensure safety and won’t fall down if the wind blows.

And there should be no signs of damage on the light pole; in addition to the light pole itself, some components on the light pole, such as battery panels, lamp arms, and light sources, must be firmly connected and not skewed, otherwise they will need to be readjusted.

installing solar street lights

The orientation and tilt angle of the battery panel are correct

Generally, the orientation and tilt angle of the battery panel will be adjusted during installation, but to avoid changes caused by variables during installation, it should be rechecked after the overall installation to ensure that the orientation and tilt angle can be accepted to the maximum extent. illumination.

Any stains, dust, etc. left during installation should also be cleaned up in time to avoid affecting the photoelectric conversion efficiency, and ensure that there are no obstructions above the battery panels.

In addition, the height and elevation angle of the lamp heads should also be checked. The height of all lamp heads should be consistent and the angle should be within 15° to ensure the lighting effect of the light source and reduce the possibility of glare.

Component installation meets specifications

In the early stage, it is necessary to strictly follow the regulations to select appropriate panels, light sources, sheathed wires, etc., and do not replace them at will. Even if there are problems with the solar street lights later in use, street light components with the same parameters must be replaced to ensure the use effect.

Otherwise, there may be a short circuit in the internal circuit or even a fire or explosion. The various settings in the controller must also be set properly. This work will be done later in the street lamp charging process. Professional equipment can be used to detect the light brightness, etc., and confirm. Every lamp meets the standards, and defective components must be replaced in a timely manner.

When everything is checked and there are no problems, and all street lights are adjusted neatly and uniformly, the solar street lights can be pre-embedded for the second time. A small base is built with cement at the base of the light pole, and the exposed bolts are covered to ensure its use. The lifespan of solar street lights can also be improved, making them safer and more aesthetically pleasing.


ZGSM Solar

We are a professional solar street light manufacturer with a 20-year history.